Phone Icon0208 953 1211       Email Iconinfo@conro.com

 x 
Cart empty

HumiSeal Stripper 1072

HumiSeal® Stripper 1072 dissolves cured HumiSeal® urethane coatings or HumiSeal® water-based acrylic coatings, without negatively affecting printed wiring board substrates or components. HumiSeal® Stripper 1072 is in full compliance with the RoHS Directive 2002/95/EC.
Manufacturer: Humiseal
Description

Typical Physical Properties of HumiSeal® Stripper 1072

Stripper

1072

Compatible HumiSeal® Coatings

1A20, 1A33, 2A64, 1H2O Products

Relative Evaporating Rate (BuAc=1)

0.66

Specific Gravity

0.99

Flash Point (°C) TCC

40.6

VOC (grams/litre)

957

Shelf Life, DOM

12 months

Colour

Blue

HumiSeal® Stripper 1072 is safe for use on copper, gold, silver or nickel plating, steel, brass, bronze, phenolic resins, amine cured epoxies, polyethylene, Teflon, Kel-F, neoprene, or vulcanized rubber. It will attack anhydride-cured epoxies and most silicones. It will either swell or dissolve polystyrene, vinyl, plexiglas, and acrylics.

Directions for Use

Immerse the component or printed circuit board assembly into HumiSeal® Stripper 1072. The rate at which the existing coating will dissolve will depend upon its thickness and age. Heating HumiSeal® Stripper 1072 will increase its effectiveness (Caution: do not exceed 48°C max). The use of mechanical mixers will speed up the dissolving rate. HumiSeal® Stripper 1072 can also be used to remove coating from small areas, by applying a few drops to the desired location.
After the existing coating has been removed, thoroughly wash the assembly in isopropyl alcohol, deionized water or other qualified cleaning process. If the component surface of is cloudy after washing, the removal is incomplete. The removal should be repeated for a longer time. Oven dry the assembly for a minimum of 30 minutes at 66°C prior to recoating.

Handling Precautions

HumiSeal® Stripper 1072 is flammable and the following standard safety precautions should be observed:
• Use only in well ventilated areas.
• Protective gloves and goggles should be worn.
• In case of prolonged skin contact, wash with water.
• In case of eye contact, flush with water followed by a diluted boric solution and contact physician.
• Avoid prolonged breathing of vapours.
• Unused portions of HumiSeal® products must be disposed of in compliance with applicable environmental regulations.
• Consult the Material Safety Data Sheet (MSDS/SDS) for more specific product information.

envelope

CONTACT US

Conro Electronics Ltd
Unit 7, Orbital 25, Dwight Road, Watford, Hertfordshire
WD18 9DA

delivery van icon

NEXT DAY DELIVERY

We offer next day and Saturday deliveries excluding orders made after 3pm weekdays, weekends and public holidays.


AS 9120B

Conro Electronics Ltd certified to the AS 9120B (Aerospace) standard

Click Here To View Our Certificate

ISO 9001:2015

Conro Electronics Ltd certified to ISO 9001:2015

Click Here To View Our Certificate