Phone Icon0208 953 1211       Email Iconinfo@conro.com

 x 
Cart empty

HumiSeal Stripper 1080EU 5 Litre

HumiSeal® Stripper 1080 5 Litre can be used to remove cured HumiSeal® acrylic coatings without negatively affecting printed wiring board substrates or components. HumiSeal® Stripper 1080 contains no ozone depleting chemicals and meets North American air quality regulations. HumiSeal® Stripper 1080 is in full compliance with the RoHS Directive 2002/95/EC.
Manufacturer: Humiseal
Description

Typical Physical Properties of HumiSeal® Stripper 1080 5 Litre

Stripper

1080

Compatible HumiSeal® Coatings

HumiSeal® Solvent Based Acrylics

Relative Evaporating Rate (BuAc=1)

1.0

Specific Gravity

1.3 ± 0.02

Flash Point (°C) TCC

21.7

Shelf Life, DOM

18 months

Colour

Clear to Reddish

HumiSeal® Stripper 1080 is safe for use on epoxy markings, epoxy substrates, solder, copper, silver, gold and nickel plating. It will swell or dissolve polystyrene and vinyl.

Directions for Use

Immerse the component or printed circuit board assembly into HumiSeal® Stripper 1080. The rate at which the existing coating will dissolve will depend upon its thickness and age. A cured acrylic coating of normal thickness should be completely dissolved within 30 minutes at room temperature. Use of additional heat is not required. Keep the container covered to prevent solvent evaporation.
After the existing coating has been removed, thoroughly wash the assembly in isopropyl alcohol, deionized water or other qualified cleaning process. Oven dry the assembly for a minimum of 30 minutes at 66°C prior to recoating.

Handling Precautions

HumiSeal® Stripper 1080 is flammable and the following standard safety precautions should be observed:

  • Use only in well ventilated areas.
  • Protective gloves and goggles should be worn.
  • In case of prolonged skin contact, wash with water.
  • In case of eye contact, flush with water followed by a diluted boric solution and contact physician.
  • Avoid prolonged breathing of vapours.
  • Unused portions of HumiSeal® products must be disposed of in compliance with all applicable environmental regulations.
  • Consult the Material Safety Data Sheet (MSDS/SDS) for more specific product information.

envelope

CONTACT US

Conro Electronics Ltd
Unit 7, Orbital 25, Dwight Road, Watford, Hertfordshire
WD18 9DA

delivery van icon

NEXT DAY DELIVERY

We offer next day and Saturday deliveries excluding orders made after 3pm weekdays, weekends and public holidays.


AS 9120B

Conro Electronics Ltd certified to the AS 9120B (Aerospace) standard

Click Here To View Our Certificate

ISO 9001:2015

Conro Electronics Ltd certified to ISO 9001:2015

Click Here To View Our Certificate